Elo-touchsystems 1000 Bedienungsanleitung Seite 32
- Seite / 40
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
This Information Technology Equipment (ITE) is required to have a CE Mark on the manufacturer’s
label which means that the equipment has been tested to the following Directives and Standards:
This equipment has been tested to the requirements for the CE Mark as required by EMC
Directive 89/336/EEC indicated in European Standard EN 55022 Class B and the Low Voltage
Directive 73/23/EEC as indicated in European Standard EN 60950.
D) General Information to all Users: This equipment generates, uses and can radiate radio
frequency energy. If not installed and used according to this manual the equipment may cause
interference with radio and television communications. There is, however, no guarantee that
interference will not occur in any particular installation due to site-specific factors.
1) In order to meet emission and immunity requirements, the user must observe the following:
a) Use only the provided I/O cables to connect this digital device with any computer.
b) To ensure compliance, use only the provided manufacturer’s approved line cord.
c) The user is cautioned that changes or modifications to the equipment not expressly
approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
2) If this equipment appears to cause interference with radio or television reception, or any other
device:
a) Verify as an emission source by turning the equipment off and on.
b) If you determine that this equipment is causing the interference, try to correct the
interference by using one or more of the following measures:
i) Move the digital device away from the affected receiver.
ii) Reposition (turn) the digital device with respect to the affected receiver.
iii) Reorient the affected receiver’s antenna.
iv) Plug the digital device into a different AC outlet so the digital device and the
receiver are on different branch circuits.
v) Disconnect and remove any I/O cables that the digital device does not use.
(Unterminated I/O cables are a potential source of high RF emission levels.)
vi) Plug the digital device into only a grounded outlet receptacle. Do not use AC
adapter plugs. (Removing or cutting the line cord ground may increase RF emission
levels and may also present a lethal shock hazard to the user.)
If you need additional help, consult your dealer, manufacturer, or an experienced radio or television
technician.
34 User Guide
- Touchmonitor User Guide 1
- User Guide 2
- Disclaimer 3
- Trademark Acknowledgments 3
- Table of Contents 4
- INTRODUCTION 5
- About the Product 6
- INSTALLATION AND SETUP 7
- Touch Interface Connection 8
- Product Overview 9
- 2-16 User Guide 14
- OPERATION 15
- Front Panel Controls 16
- Controls and Adjustment 17
- OSD Control Options 18
- Preset Modes 19
- Display Angle 20
- TROUBLESHOOTING 21
- 4-24 User Guide 22
- NATIVE RESOLUTION 23
- TOUCHMONITOR SAFETY 25
- TECHNICAL SPECIFICATIONS 27
- Touchmonitor Specifications 28
- C-32 User Guide 30
- REGULATORY INFORMATION 31
- EN60950-1 33
- WARRANTY 35
- INDEX 37
- I N D E X - 40 38
- Check out Elo’s Web site! 40
Philips SHM1900-93 manuali
Manuali dei proprietari e guide per l'utente per Video Philips SHM1900-93.
We fornisce 1 manuali pdf Philips SHM1900-93 per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Kommentare zu diesen Handbüchern