
3-23
Next, refer to the appropriate page to continue your installation:
Touchmonitor with Internal Serial Controller
Contents
This configuration includes a touchmonitor with an internal 2210 serial
controller and a serial cable. Actual configuration may vary due to third-party
integrations.
Installation
The 2210 controller is internal to the monitor and is shipped preconfigured for
use with Elo software.
Complete these steps:
1 Plug the DB9 male end of the supplied serial cable into the DB9 female
connector typically labeled "Touch Interface" on the back of the
touchmonitor case.
2 Plug the DB9 female end of this cable into the computer's DB9 serial port. If
you have a 25-pin serial port, use a DB9 male to DB25 female adapter.
Proceed to “Where to Go from Here” on page 3-30.
Controller Configuration Page
2210 Touchmonitor with Internal Serial Controller 23
3000U Touchmonitor with Internal USB Controller 24
2210 2210MX External Serial Controller 25
2201 PC-Bus Controller 27
Kommentare zu diesen Handbüchern