
3-26 Elo Entuitive Touchmonitor
4 Plug the keyboard cable into the female connector on the Y end of the
adapter cable.
5 Plug the other end of the adapter cable into the connector on the serial cable.
6 Plug the DB9F end of the attached serial cable into a serial port.
7 Proceed to “Where to Go from Here” on page 3-30.
Complete the following steps if you are using a wall mount power supply
:
1 Two different wall mount power supplies are available. Use Elo P/N 580979-
000 if you are using this inside the United States and Elo P/N 319865-000 if
you are using this outside of the United States.
2 Plug the single male connector on one end of the power supply into the
connector on the serial cable.
3 Plug the other end of the power supply into a proper receptacle.
4 Plug the DB9F end of the attached serial cable into a serial port.
Proceed to “Where to Go from Here” on page 3-30.
Figure 3.2
External Serial Controller Installation
Touchscreen
monitor
Male 9-pin
touchscreen
connector
Female 15-pin
video
connector
Monitor
power cable
External serial
touchscreen
controller
Alternate keyboard
controller power cable
Video
cable
Controller
power supply
Touchscreen
cable
Kommentare zu diesen Handbüchern