Elo TouchSystems Elo IntelliTouch Anleitung zur Fehlerbehebung Seite 30

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 105
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 29
2-18 IntelliTouch/SecureTouch Guide
Attaching the Touchscreen
Once you have verified all dimensions and checked that the bezel has plenty of
clearance around the transducers and lands inside the sealing area, you are ready
to install the touchscreen.
1 Check room for cable routing:
Route away from noise sources (flyback transformer, power supply, yoke,
high voltage lead, etc.)
Cable can be on either side.
Avoid pinch points.
Make up excess cable with tie wraps.
2 Ensure the display and touchscreen and are clean before installation.
Use black background to ensure fingerprints and smudges are not visible.
Compressed air is best to remove dust.
3 Use double-sided high tack adhesive tape
3
on all four sides to attach the
touchscreen to the display.
3 mm thick for curved
2 mm thick for flats > 15"
1 mm thick for flats <= 15"
Acts as dust seal as well as an adhesive. (Make a flat “T” in corners for
dust seal.)
Or substitute foam tape on two sides
Or use metal frame on flats, but still use foam tape for dust seal.
3.Refer to “Elo Part Numbers” on page C-79 to ensure you are using the proper
adhesive
Seitenansicht 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 104 105

Kommentare zu diesen Handbüchern

Keine Kommentare