Elo TouchSystems Elo IntelliTouch Anleitung zur Fehlerbehebung Seite 74
- Seite / 105
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
B-62 IntelliTouch/SecureTouch Guide
IntelliTouch Touchscreens
Mechanical
Construction
Glass panel with transducers attached to front surface of the glass. Glass panel thickness
nominally 0.115-inch (3 mm). Corner-mounted transducers add maximum of 0.150-inch
(4 mm). Beveled flat screens have transducers attached to a beveled edge of the glass.
Dimensions
The following physical dimensions of the touchscreen are specified for each model in the
IntelliTouch Touchscreen Products brochure or the appropriate Elo Specification Control
Drawing. Drawings can be found on Elo’s web site, www.elotouch.com
Horizontal and Vertical physical size
Horizontal and Vertical border region size
Horizontal and Vertical touch active area size
Radius of curvature information
Cable exit location, length, and connector type
Cable and
Connector
Cable typically exits from the right side, terminating in a 2x6 female, 0.025-inch (0.635
mm) square post receptacle with 0.100-inch (2.54 mm) centers.
Positional
Accuracy
Standard deviation of error is less than 0.080 in. (2 mm).
Resolution
4096 x 4096 touch points (approximately 400 touch points per linear inch)
Touch Activation
Force
Typically 2 to 3 ounces (55 to 85 grams).
Surface
Durability
Surface durability is that of glass, Mohs’ hardness rating of 7.
Expected Life
Performance
No known wear-out mechanism, as there are no layers, coatings, or moving parts. The
IntelliTouch technology has been operationally tested to more than 50 million touches in
one location without failure, using a stylus similar to a finger.
Optical
Light
Transmission
90% per ASTM D1003-92
Visual Resolution
Clear surface: Excellent with no noticeable degradation.
Anti-glare surface: 6:1 minimum.
All measurements made using USAF 1951 Resolution Chart, under 30X magnification
with test unit located approximately 1.5-inch (38 mm) from surface of resolution chart.
Gloss
Clear surface: N/A
Antiglare: 75 ± 15 gloss units per ASTM D2457-90 using a 60° gloss meter. For flats, 85
± 15 gloss units per ASTM D2457-90.
Electrical
All touchscreen drive signals are developed by the interfacing controller. Refer to the
Technical Reference Manual for your controller or to the IntelliTouch Touchscreen
Products brochure for these specifications.
Environmental
Temperature
Operating: -20°C to 50°C.
Storage: -40°C to 71°C.
Operating
Relative Humidity
40°C at 90% Rh, non-condensing.
- Elo IntelliTouch 2
- /SecureTouch 2
- Touchscreen Guide 2
- All Rights Reserved 3
- Disclaimer 3
- Trademark Acknowledgments 3
- Table of Contents 7
- Appendix B 8
- Appendix C 8
- List of Figures 9
- List of Tables 11
- ECHNOLOGY 13
- The IntelliTouch Touchscreen 14
- Figure 1.1 14
- The IntelliTouch Controller 15
- Figure 1.2 15
- Driver Software 16
- Agency Approvals 16
- NSTALLATION 17
- OMPONENT 17
- Getting Started 18
- Bezel Design 19
- CRT Integration 20
- Definition of Terms: 21
- Suggested Tools 21
- Figure 2.3 22
- Unpacking the Touchscreen 23
- Testing the Monitor 23
- Remove the Back Case 24
- Discharge the CRT 24
- Remove the Electronic Chassis 25
- Remove the CRT 27
- Verify Touchscreen Fit 28
- Attaching the Touchscreen 30
- Figure 2.4 31
- Installing the Controller 33
- Figure 2.5 34
- P4 Pins Signal Function 35
- External Serial Controller 37
- Figure 2.6 39
- Reassembling 41
- Sealing the Monitor 42
- Figure 2.7 42
- Figure 2.8 43
- LCD Integration 44
- Definition of Terms 46
- Tools and Equipment 47
- Removing the Rear Case 49
- Removing the LCD 49
- Determining Touchscreen Fit 50
- Mounting the Touchscreen 51
- Figure 2.9 52
- Figure 2.10 54
- Figure 2.11 55
- Parasitic Tap of 5Vdc 56
- Figure 2.12 57
- Figure 2.13 59
- Brush Direction 59
- ROUBLESHOOTING 61
- Display Problems 62
- Software Troubleshooting 62
- Hardware Troubleshooting 63
- Using the COMDUMP Utility 64
- Byte Description 65
- Byte MSB LSB 65
- RS-232 Connections 66
- Power Connections 67
- Figure A.2 68
- IC1 Cable 69
- EC2 Cable 69
- Diagnostic LED's 70
- Table A.3 71
- Figure A.4 72
- PECIFICATIONS 73
- IntelliTouch Touchscreens 74
- Approvals 75
- Touchscreen 77
- Connector 77
- Power Connector, P4 77
- Figure B.1 78
- Table B.1 78
- Figure B.2 78
- Figure B.3 78
- Table B.2 79
- Table B.3 79
- Figure B.4 81
- Figure B.5 81
- Figure B.6 82
- Figure B.7 82
- Electrical 83
- Environments 83
- Physical Characteristics 83
- Cable applied 84
- Board mounted 84
- Table B.4 85
- Table B.5 85
- Figure B.9 86
- Table B.6 86
- Figure B.10 86
- Jumper Settings 87
- Figure B.11 89
- Figure B.12 89
- Figure B.13 90
- Figure B.14 90
- Controller and Cable Kits 91
- IntelliTouch® Accessories 91
- Part Number Description 92
- Glossary-83 95
- standard 96
- Glossary-85 97
- Glossary-87 99
Verwandte Produkte und Handbücher für Fernseher & Monitore Elo TouchSystems Elo IntelliTouch
(28 Seiten)
(59 Seiten)
(47 Seiten)
(26 Seiten)
(54 Seiten)
(56 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 4.858 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern